Contact Us

Bond Work Index an overview ScienceDirect Topics

The ball mill work index laboratory test is conducted by grinding an ore sample prepared to 100% passing 3.36 mm (6 mesh) to product size in the range of 45-150 µm (325-100 mesh), thus determining the ball mill work index (WiB or BWi).

Bond Work Index Procedure and Method

2021-3-18  This Grindability Test or Bond Ball Mill Work Index Procedure is used to determine the Bond Work Index of minus six mesh or finer feed ore samples. These equation application methods are used to process <1/2″ ore samples in a Ball Mill using a standard ball charge. Below describes in general terms the Bond Work Index

Testwork: Bond ball mill work index SAGMILLING.COM

2020-12-9  The Bond ball mill work index is one of the most commonly used grindability tests in mining, and is often referred to as the Bond work index. The test is a 'locked-cycle' test where ground product is removed from test cycles and replaced by fresh feed. The test much achieve a

Bond Tests SGS

The test determines the Bond Rod Mill Work Index which is used with Bond’s Third Theory of Comminution to calculate net power requirements when sizing ball mills*. Various correction factors may have to be applied. The test is a closed-circuit dry grindability test performed in a standard rod mill.

Standard Bond Ball Mill Grindability Test Method

2021-3-10  Here is the old Allis-Chalmers Bond Work Index Grindability Test Procedure. The standard feed is prepared by stage crushing to all passing a 6 mesh sieve, but finer feed can be used when necessary. It is screen analyzed and packed by shaking in a 1000-cc graduated cylinder, and the weight of 700 cc is placed in the mill and ground dry at 250 per cent circulating load. The mill is 12 in. x 12

Comminution testing JKTech University of

A Bond Ball Mill Work Index may also be used in the simulation and optimisation of existing mill(s) and the associated grinding circuit(s). Sample requirements: A minimum of 8 kg of material crushed to nominally minus 10 mm is preferred. JKTech would stage crush the sample to minus 3.35 mm, as required for the Bond Ball Mill Work Index test feed.

(PDF) A quick method for bond work index

The Bond work index is a measure of ore resistance to crushing and grinding and is determined using the Bond grindability test. Its value constitutes ore characteristic and is used for industrial...

USING THE SMC TEST® TO PREDICT COMMINUTION

2020-3-24  work index covering grinding of fine particles is labelled M. ib (Morrell, 2008). M. ia. values are provided as a standard output from a SMC Test ® (Morrell, 2004. a) whilst M. ib. values can be determined using the data generated by a conventional Bond ball mill work index test (M. ib. is NOT the Bond ball work index). M. ic. and M. ih