Contact Us

Partial Replacement of Sand by Quarry Dust in Concrete

This paper reports the experimental study which QUARRY DUST: Crushed rock aggregate quarrying investigated the partial replacement of sand with quarry dust. generates considerable volumes of quarry fines, often termed Initially cement concrete cube was studied with various “quarry dust”.

Partial Replacement of Sand by Quarry Dust in Concrete

investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, AND M25). The experimental results showed that the addition of quarry dust as fine aggregate ratio of 30%, 40% and 50% was found to enhance the compressive properties.

(PDF) Use of Quarry Dust to Replace Sand in Concrete An

This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to 100% in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive.

Use of Quarry Dust to Replace Sand in Concrete An

clear picture that quarry dust can be utilized in concrete mixtures as a good substitute for natural river sand giving higher strength at 50% replacement. Index Terms- Concrete, quarry dust, river sand, compressive strength. I. INTRODUCTION oncrete is the most widely used composite material today.

USE OF QUARRY DUST IN CONCRETE AS REPLACEMENT FOR

mix quarry dust in sand then only 65% to 75% of sand replaced by quarry dust because strength of concrete is affected by this process. In other process if we mix quarry dust and fly ash are added together in concrete mix then we replace complete sand by quarry dust and fly ash. The use fly

Partial Replacement of Sand with Quarry Dust in Concrete

Partial Replacement of Sand with Quarry Dust in Concrete. -The reduction in the sources of natural sand and the requirement for reduction in the cost of concrete production has resulted in the increased need to identify substitute material to sand as fine aggregates in the production of

(PDF) Study on Performance of Quarry Dust as Fine

The suitability of quarry dust as alternative material for the river sand in concrete manufacturing is studied. M25 grade concrete was prepared with 0%, 20%, 40%, 60%, 80% partial replacement of

Can we make concrete using quarry dust as a replacement

Hello, It is not possible to make concrete out of quarry dust, since quarry dust is a waste product that is produced during M Sand / stone crushing process. To make concrete, it is necessary to make use of sand or M Sand (An alternative for river sand). Thank you.

Can Quarry Dust Replace Sand in a Cement Mix

Quarry Dust and Cement Mix. Recent research into the potential of quarry dust in cement mixes have focused upon a partial replacement of the sand. The results to far suggest that a cement mix made of quarry dust has an increased workability, making it more flexible and easy to use, but there are doubts about its durability, and compressive

Partial Replacement of Sand with Quarry Dust in Concrete

This present work is an attempt to use Quarry Dust as partial replacement for Sand in concrete. Attempts have been made to study the properties of concrete and to investigate some properties of Quarry Dust the suitability of those properties to enable them to be used as partial replacement materials for sand in concrete.

Introduction to Quarry-Dust as Partial Replacement

In one more investigation where natural sand is replaced 100% with quarry dust to study the physical properties, mechanical properties and durability of concrete made by quarry dust with done by R. Ilangovana,N. Mahendrana and K. Nagamanib [7].Mix design has been developed for M20, M30 and M40 grade of concrete for both conventional concrete

The potential of quarry dust (QDC) as partial sand

Quarry dust is used as partial sand replacement for sand namely as QDC5, QDC10, QDC15, QDC20 and QDC25 for 5%, 10%, 15%, 20% and 25% replacement respectively following normal concrete as OPC. All specimens were tested for compressive strength at the age of 7, 14 and 28 days.

Quarry Dust For Sand Replacement In Concrete

[PDF] Use of Quarry Dust to Replace Sand in Concrete An. This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to 100% in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7

Effect of quarry rock dust on the flexural strength of

Jun 01, 2018 The use of quarry dust as replacement for sand in concrete has been extensively researched in recent years. This stems from the fact that there is growing concern in most parts of the world about the depletion of sand deposits, environmental and socio-economic threats associated with extraction of sand from river banks, coastal areas and farm

Stone Dust in Concrete: Effect on Compressive Strength

found that the compressive and flexural strength of concrete made of Quarry Rock Dust are nearly 10% more than the conventional concrete (Suribabu et al., 2015). In the present study it is proposed to investigate the optimum replacement of river sand with stone dust for concrete in term of compressive strength performance at 7 days and 28 days. II.

Experiment on Foam Concrete with Quarry Dust as Partial

of concrete made of quarry dust and results were compared with the control foam concrete. It is found that the compressive strength of foam concrete made of quarry dust are nearly 40 % more than the control foam concrete. replacement material to sand as fin. Keywords— Foam Concrete, Aerated concrete, Foaming agent, Bubbles.

Use of Quarry Fine as Partial Replacement of Concrete as a

quarry dust the concrete produced compared well with normal concrete. He recommended quarry dust for replacement with sand in general concrete structures. Ilangovana et al., [12] studied the strength and durability properties of concrete containing quarry dust as fine

Replacement of cement by glass powder and sand quarry dust

Aug 14, 2014 •The ideal percentage of the replacement of sand with the quarry dust is 55% to 75% in case of compressive strength. •The further increasing the percentage of replacement can be made useful by adding the fly ash along with the quarry dust so that 100% replacement of sand

An Innovative Method of Replacing River Sand by Quarry

This paper deals with replacement of sand used in concrete as fine agg. regates by the waste generated by the stone quarry industry. This study has made . an attempt to partially replace quarry dust in place of sand in M35 grade concrete. On experimentation, it was found that the. partial replacement of sand . with. 10% of quarry du. st. has given

Improved Concrete Properties Using Quarry Dust as

Apr 08, 2015 Table 3 The results show that there is an increase in the compressive strength of the concrete [3,4] which the increment is about 55% to 75% depending on the replacement if the sand with the quarry dust, for the 100% replacement of the sand the compressive strength is depending on the quarry dust location from where the quarry dust was taken.

Behaviour of Concrete on Replacement of Sand with Quaries

In order to study the strength behaviour and fire resistance of the concrete made with full replacement of sand with Quarry stone dust the tests are conducted. Results so obtained for the tests conducted on cubes and prisms for M25 and M40 grades of concrete with various dosages of super plasticiser at 7days and 28 days were tabulated.

What are the advantages of using quarry dust as fine

The concept of replacement of natural fine aggregate by quarry dust which is highlighted in the study could boost the consumption of quarry dust generated from quarries. By replacement of quarry dust, the requirement of land fill area can be reduc...